“GT2 Toothed Idler Pulley 20Teeth 5mm Bore 6mm Belt” has been added to your cart. View cart

Sale

Bigtreetech Octopus Pro V1.1 H723 Control Board

Name: Bigtreetech Octopus Pro V1.1 H723 Control Board
SKU: DC-541
Availability: InStock

Original price was: 5,999.00₹.Current price is: 5,599.00₹.

(In Stock)

Compare

Add to wishlist

SKU: DC-541 Categories: Bigtreetech Products, Electronics, RatRig Printer Parts, Voron Trident Parts, Voron V2.4 Parts

Main Control Chip】The main control board uses 32-bit ARM-level Cortex-M4 series STM32H723ZE chip with a frequency of up to 168MHz and the flash is 1MB.

【Support 60V Input】Supports up to 8 3D printer motherboards with a maximum 60V stepper motor. The motor drive power supply supports up to 60V input (only for the motor drive power supply).

【6 Controllable Fans】Up to 6 controllable fans, two normally open fans, and both support power supply voltage, 12V, 5V options.

【Update Firmware: Klipper/Marlin/RRF】Supports firmware update via DFU mode. This is where the firmware is sent to the board directly from the PC and does not require a bootloader however this method is not recommended for novice users as discussed later in this document.

【Level conversion IC】Supports proximity sensor, jumper optional pull-up resistor, supports more models, supports BL Touch.